connect to leappad 2

[vlotho]

hello,
I think the subject has been discussed many times but the subjects are very old, the photos are also no longer available, and I cannot find any on the net.
I try to access my leappad 2 by the shell, to be able to export all its contents (maybe there is another solution but I did not find them).
So there you have it, I have a usb to ttl cable with the 4 pins that come out (black, gray, red, green), but I cannot find a soldering or connection plan (on the leappad 2, not on the didj ).
Do I have to weld them on the cartridge or directly in the console and where exactly.

[Kris_Perry]

hello,
I think the subject has been discussed many times but the subjects are very old, the photos are also no longer available, and I cannot find any on the net.
I try to access my leappad 2 by the shell, to be able to export all its contents (maybe there is another solution but I did not find them).
So there you have it, I have a usb to ttl cable with the 4 pins that come out (black, gray, red, green), but I cannot find a soldering or connection plan (on the leappad 2, not on the didj ).
Do I have to weld them on the cartridge or directly in the console and where exactly.

If you just want to transfer files, you should use File Transfer Protocol(FTP) as per This Guide.

1. install the LoadDev dev mode toggle.
2. Toggle into dev mode, check your leappads new IP, 
3. connect via FTP over USB and transfer your files that way.
4. Don't forget to Toggle out of dev mode when you're finished or Leappad Manager will not connect to your device.