08-19-2017, 10:26 AM
The LeapPad should have an IP of 192.168.0.111 unless that got changed. So in order to connect to it, you must be on the same subnet as it or you won't be able to reach that IP. This is why you must set the IP of the adapter to 192.168.0.X which in my tutorial is just 1, but really any number should work within the address range of course.
Mine always seemed to work and my other adapters for my internet were on 13.x, but as long as the leappad adapter was on 0.x so it was on the same subnet as the leappad, it should work.
You can try the repair mode, but not sure if that resets the flag or not.
Leap Pad 2:
Power on the device while holding home, vol down and right on the directional pad. This will boot up to a repair mode where you can then connect it to a computer and attempt to restore the firmware
Mine always seemed to work and my other adapters for my internet were on 13.x, but as long as the leappad adapter was on 0.x so it was on the same subnet as the leappad, it should work.
You can try the repair mode, but not sure if that resets the flag or not.
Leap Pad 2:
Power on the device while holding home, vol down and right on the directional pad. This will boot up to a repair mode where you can then connect it to a computer and attempt to restore the firmware