12-26-2015, 09:51 AM
(This post was last modified: 12-26-2015, 10:04 AM by Deak Phreak.)
I am not sure the default price of the device, but $50 does sound decent to me and have yet to pick one up. I may have to just so I can join in on the fun.
You can download Buildroot and compile it for the device.
Target Architecture (ARM (little endian))
Target Binary Format (ELF)
Target Architecture Variant (cortext-A9)
Target ABI (EABI)
Floating point strategy (Soft float)
ARM instruction set (ARM)
Change the "C library" to "uClibc" and the change the "uClibc C library Version to (uClibc 0.0.33.x)
"GCC compiler Version" if not already set this to "gcc 4.9.x"
check the box for "Enable C++ support"
if you want to create a gfx application for the leaptv? Well we can use SDL.
Hope that helps. The cartridges just have an SD card which are ext4 so you can "make your own" if you wish.
I found some on Ebay that come with more for about the same price so I am going to try there first to snag one up.
You can download Buildroot and compile it for the device.
Target Architecture (ARM (little endian))
Target Binary Format (ELF)
Target Architecture Variant (cortext-A9)
Target ABI (EABI)
Floating point strategy (Soft float)
ARM instruction set (ARM)
Change the "C library" to "uClibc" and the change the "uClibc C library Version to (uClibc 0.0.33.x)
"GCC compiler Version" if not already set this to "gcc 4.9.x"
check the box for "Enable C++ support"
if you want to create a gfx application for the leaptv? Well we can use SDL.
Hope that helps. The cartridges just have an SD card which are ext4 so you can "make your own" if you wish.
I found some on Ebay that come with more for about the same price so I am going to try there first to snag one up.