01-30-2015, 11:57 PM
I've been looking at the LeapPad2 and the NXP3200 seems to be a nice little processor. I only have one issue, does anyone have a board with the processor removed? I'm looking to do some discovery on the processor and I want to first see what pins are actually available and wired where. It seems to be a nice little platform for a drone. I'm hoping the PWM outputs are available somewhere on the board and aren't used for the LCD. If that is the case, then I might have to resort to external PWMs... Not ideal. At any rate, if anyone has the board schematic, or barring that, a board with no processor, I'd like to know. I thought I'd put the feelers out there first before I have to chip one off myself (I have a few available for just such purposes, but if I can keep them running, I'd like to eventually incorporate them.)...
Once I've got a better idea what's available, I'm going to start looking around at possible frame ideas. I was hoping for a four rotor design seeing as I've got two PWMs available. I suppose a six rotor design could work as well, but I'm trying to keep it simple.
Once I've got a better idea what's available, I'm going to start looking around at possible frame ideas. I was hoping for a four rotor design seeing as I've got two PWMs available. I suppose a six rotor design could work as well, but I'm trying to keep it simple.